|
 BB-B1-4000C PUMP CONTROLLER |
Page 2 of 2 |
|
THE CONNECTING OPTIONS |
|
| Connection of Upper/Lower Pool Water-supply(1) |
Connection of Upper/Lower Pool Water-supply(2) |
 |
|
| Note: after setting the no-load protect, can not connect probe in lower pool. When the water comes to M in upper pool, it will start pumping water and stop at H, the signal of L is for loop. |
Note: signal lines should be purchased and can not set at No-load (its 000). When the water comes to M in upper pool, it will start pumping water and stops at H. When the water comes to H in lower pool, it will start pumping water and stop at M, which is lack water protect. All the signal lines are for loop. |
| |
|
| Connection of Upper/LWaste-Drainage Water supply connection(3) |
Stable-pressure connection (4) |
 |
|
| Note: When the water comes to H, it will start pumping water and stop at M, The L signal lines is for loop. |
Note: the water pressure is down to Min. the pointer will increase pressure to Max. for stop. The flexible pointer is for loop. Please use the proper size pressure meter, if the meter is too small, it will cause frequent reset. |
| |
|
| |
|
| Total Pages: 1 2 |
PREVIOUS NEXT |
| |
|
|
|
|
|
Home >> Products >> BB-B1-4000C pump controller 
